In Vitro
Digestion–In Situ Absorption Setup
Employing a Physiologically Relevant Value of the Membrane Surface
Area/Volume Ratio for Evaluating Performance of Lipid-Based Formulations:
A Comparative Study with an In Vitro Digestion–Permeation Model
Posted on 2024-05-29 - 14:03
The aim of this study is to establish
and test an in vitro digestion–in
situ absorption model that can mimic in vivo drug flux by employing
a physiologically relevant value of the membrane surface area (S)/volume (V) ratio for accurate prediction
of oral drug absorption from lipid-based formulations (LBFs). Three
different types of LBFs (Type IIIA-MC, Type IIIA-LC, and Type IV)
loaded with cinnarizine (CNZ), a lipophilic weak base with borderline
permeability, and a control suspension were prepared. Subsequently,
a simultaneous in vitro digestion–permeation experiment was
conducted using a side-by-side diffusion cell with a dialysis membrane
having a low S/V value. During digestion,
CNZ partially precipitated for Type IV, while it remained solubilized
in the aqueous phase for Type IIIA-MC and Type IIIA-LC in the donor
compartment. However, in vitro drug fluxes for Type IIIA-MC and Type
IIIA-LC were lower than those for Type IV due to the reduced free
fraction of CNZ in the donor compartment. In pharmacokinetic studies,
a similar improvement in in vivo oral exposure relative to suspension
was observed, regardless of the LBFs used. Consequently, a poor correlation
was found between in vitro permeation and areas under the plasma concentration–time
curve (AUCoral) (R2 = 0.087).
A luminal concentration measurement study revealed that this discrepancy
was attributed to the extremely high absorption rate of CNZ in the
gastrointestinal tract compared to that across a dialysis membrane
evaluated by the in vitro digestion–permeation model, i.e.,
the absorption of CNZ in vivo was completed regardless of the extent
of the free fraction, owing to the rapid removal of CNZ from the intestine.
Subsequently, we aimed to predict the oral absorption of CNZ from
the same formulations using a model that demonstrated high drug flux
by employing the physiologically relevant S/V value and rat jejunum segment as an absorption sink (for
replicating in vivo intestinal permeability). Predigested formulations
were injected into the rat intestinal loop, and AUCloop values were calculated from the plasma concentration–time
profiles. A better correlation was found between AUCloop and AUCoral (R2 = 0.72),
although AUCloop underestimated AUCoral for
Type IV due to the precipitation of CNZ during the predigestion process.
However, this result indicated the importance of mimicking the in
vivo drug absorption rate in the predictive model. The method presented
herein is valuable for the development of LBFs.
CITE THIS COLLECTION
DataCiteDataCite
No result found
Tanaka, Yusuke; Arai, Hinata; Hidaka, Aya; Noda, Saki; Imai, Ko; Tsujisawa, Fumiya; et al. (2024). In Vitro
Digestion–In Situ Absorption Setup
Employing a Physiologically Relevant Value of the Membrane Surface
Area/Volume Ratio for Evaluating Performance of Lipid-Based Formulations:
A Comparative Study with an In Vitro Digestion–Permeation Model. ACS Publications. Collection. https://doi.org/10.1021/acs.molpharmaceut.4c00161